Duplo DF-1000, Инструкция по эксплуатации

Страница: 39 / 86

3-11
The function setting mode is a function for shortening the operation procedure or adjusting
according to the paper used based on the purpose of the user.
The function setting mode consists of the following eight types.
4. FUNCTION SETTING MODE
No. Mode Purpose Default setting
1 Non-standard paper
length setting Set and register the paper length when standard folding
non-standard paper. OFF
2 Operation mode setting Setting for shortening the operation procedure. Select
from three modes “NORMAL”, “LAST TIME FOLD”, and
“STOPPER FIXED”. NORMAL
3 Interval setting Setting this setting to ON repeatedly pauses operations
for every specified number of sheets and restarts
operations after several seconds. The pause time can be
selected from “3 SEC”, “5 SEC”, and “10 SEC”. OFF
4 Separating air strength
setting The separating air volume can be selected from
“NORMAL” and “LIGHT” according to the paper
thickness. NORMAL
5 Paper feed interval
setting The processing speed for single fold, double fold, and
letter fold of standard paper can be selected from “FAST”,
“NORMAL”, and “SLOW”. NORMAL
6 Stacking amount setting The volume of paper stacked on the paper feed tray can
be selected from “HIGH”, “NORMAL”, “LOW”. HIGH
7 Stacker belt setting Select the operations of the stacker belt from two modes
“NORMAL” and “CONTINUOUS”. NORMAL
8 Thick paper stopper
correction setting The correction value of the folding stopper positions of
the folding plates can be changed for thick paper. Select
“NOT CORRECTED” or “CORRECTED”. NOT
CORRECTED
The No. 1 registered data of paper length will be preserved even after the power is turned
off when the No. 2 operation mode setting is set to last time fold mode.
The No. 2, 4 to 8 settings will be preserved even after the power is turned off.
The No. 3 setting will be erased when the power is turned off.
4-1. Non-standard Paper Length Setting
Set and register paper length in this mode when using non-standard paper.
For details, refer to “1. STANDARD FOLDING OF NON-STANDARD PAPER” ( p.3-2).