Duplo DF-1000, Инструкция по эксплуатации

Страница: 33 / 86

3-5
1
C r e a t e t h e f o l d i n g s a m p l e o f
accordion fold with the paper to be
used.
Custom folding is the method of folding paper by specifying and registering the positions (folding
positions) of the folding stoppers of folding plates 1 and 2.
2. CUSTOM FOLDING
2-2. Operation Procedure
Paper feed direction
Paper
Length: 182 to 432 mm
Width: 120 to 297 mm
2
Measure the size of each folded plane
(A and B) of the sample, and the
folded paper length C.
Length of
folded plane
However, the length of the folded plane (see
right figure ) which can be folded by folding
plates 1 and 2 is restricted.
Do not set the folded paper length to above
250 mm.
Folding plate 1 : 42 to 325 mm
Folding plate 2 : 0 mm*/47 to 217 mm
∗
As folding plate 2 is not used in single folding, it is 0
mm.
The following describes the custom folding procedure taking accordion fold as an example.
Ejection
direction
Paper feed
direction
A (200 mm)
B (95 mm)
C (105 mm)
2-1. Paper Size Restrictions
Paper sizes which can be used are the sizes
within the range shown on the right.
To insure the quality of the fold
when paper width is 120 mm, it is
recommend not to exceed 240 mm in
length.
3
Turn on the power switch.
4
Stack paper on the paper feed tray.
5
Move the side guides according to the paper width.