Duplo DF-1000, Инструкция по эксплуатации

Страница: 22 / 86

2-2
3
2
1
3
2
1
3
2
1
3
2
1
3
2
1
Stacking
direction
Paper size
A3 B4
A4
B5 A5 B6
× × × ×
1-1. Standard Paper
There are six types of standard paper sizes; A3, B4, A4, B5, A5, and B6. All these sizes are
detected as standard paper only when stacked in the short edge feeding direction (direction
shown in the figure).
1. STANDARD FOLDING OF STANDARD PAPER
Paper
Table of paper stacking direction
: Can be used as standard paper
: Can be used as non-standard paper
×
: Cannot be used
1-2. Standard Folding Modes
There are five types of standard folding modes; single fold, double fold, irregular accordion
fold, letter fold, and accordion fold.
Single
fold
Double
fold
Irregular
accordion fold
Letter
fold
Accordion
fold
Paper feed direction
Paper stacked on
paper feed tray
<Single fold> <Double fold>
<Irregular accordion fold> <Letter fold> <Accordion fold>
Ejection
direction
For A4 and B5 sizes, these can be
used as non-standard paper even
when stacked in the long edge feeding
direction. (Refer to Chapter 3 APPLIED
USE “1. STANDARD FOLDING OF
NON-STANDARD PAPER” ( p.3-2).)
When stacking paper on the paper feed tray, take note of the front/back, top/end of the
paper.
Because the relations between the folding misalignment state and the front/back, top/
end of the paper must also be taken into consideration when checking the finish by test
folding.
<Example> When paper (front is gray and back is white) is stacked on the paper feed tray as
shown and finished in the following standard folding modes