14
OPERATOR TROUBLESHOOTING
PROBLEM
CORRECTIVE ACTION
Fasteners will not drive completely into wood.
Fasteners penetrate properly during normal
operation, but won't drive fully at faster speeds.
Fasteners drive too deeply into wood.
Tools skips during operation - no fasteners are
driven from time to time.
Tool operates, but no fasteners are driven.
Air leaks when tool is connected to air.
Adjust work contacting element (retract length).
Increase air pressure (do not exceed 120 psi).
Increase air flow to tool -- use larger air lines.
Adjust work contacting element (extend length).
Reduce air pressure.
Check magazine for proper fasteners. Magazine fol-
lower should slide freely. Clean as needed to remove
debris.
Make sure correct fasteners are being used.
Use fasteners that meet
Duo-Fast
®
specifications
Increase air flow to tool -- use larger air lines.
Adjust work contacting element.
Check magazine for proper fasteners. Fasteners
should slide freely with no follower pressure.
Increase air pressure (do not exceed 120psi).
Tighten screws and fittings.
No cap feed.
Check Cap feed switch to make sure it is in the cap
feed position.
Cap chain may be broken in track. Thread caps from
canister to pusher.
14
CAUTION
Disconnect the tool when performing
repairs or clearing jams.
only.