Blind size
Trimmable Roman Blind Fitting Instructions
- Please read carefully before commencing
We recommend a professional or a person competent in DIY
undertake this installation.
Tools Required for hanging the blind
Drill 6mm Drill Bit Screw Driver Hack Saw Pencil
Please note:
Additional fasteners other than those sent with your blind may be required depending on the mounting surface.
Wallboard and plaster require the use of anchors such as expansion or toggle bolts. Brick, tile or stone need special plugs and drill bits.
Remember to always pre-drill holes in wood to avoid splitting.
What is included
Headrail
Wall supports Cord guides
Cord pulley
Split cord
Cord pull
Cord
Roman
Clip on rod
Clip on hem
Clip on
Loop
Screws &
(with end cap)
(with cords)
collector
cleat
rods
bar
bar
cord toggles
tape
wall plugs
61cm / 24” / 2ft 1
2
2
1
1
1
1
7
5
1
2
1
4
91cm / 35” / 3ft 1
2
2
1
1
1
1
7
5
1
2
1
4
122cm / 48” / 4ft 1
3
3
1
1
1
1
7
5
1
3
1
5
153cm / 60” / 5ft 1
4
3
1
1
1
1
7
5
1
3
1
6
183cm / 72” / 6ft 1
4
4
1
1
1
1
7
5
1
4
1
6
WARNING
Young children have been strangled by loops in pull-cords,
chains and tapes, and cords that operate the product.
To avoid strangulation and entanglement, keep cords out of the reach
of young children. Cords may become wrapped around a child’s neck.
Move beds, cots and furniture away from window covering cords.
Do not tie cords together.
Make sure cords do not twist and create a loop.
Cut the cord to suitable length to ensure it can be wound around
the cleat several times when your roman blind is both open and closed.
Children can strangle if the cleat device is not installed.
Always use this device to keep cords out of reach of children.
(with end caps)
Keep out of the reach of young children.
Small parts - choking hazard.
headrail
Positioning the blind
You can choose to fit your blind inside or outside your window recess as shown.
We recommend that when fitting outside the recess, that you fit your blind
5- 15cm past each side of the window as shown to prevent light bleeding
through the sides.
If fitting inside the recess, position the headrail so that it will be clear of any
latches and window fixtures.
If the blind is not a suitable size, you can trim it to fit following the instructions
on the next page.
check bracket
will not clash
with ends or
cord guides
Fixing the wall support brackets
The brackets can be fitted for face or top fixing to your frame,
wall or ceiling.
Mark and drill the screw holes then screw the brackets into place.
Position the brackets to leave a gap of at least 2cm between the
end brackets and the end of the headrail at either side of the blind.
The brackets should be evenly spaced along the width of the blind
to secure and level – make sure that the brackets don’t clash with
ends or cord guides.
For easy installation this blind is pre-corded for you.
