Installing & Changing Preamp Modules.
Installing modules is quick and easy. Plug the modules
into their receptacles located under the"
Quick Access" plate on the top of the amp.
To install your modules just follow these easy steps:
1. Choose the module arrangement you wish to try. (See pages 4-5 for some ideas or the
instruction sheet in your module pack for the suggested order of installation.)
2. Choose the module you want to install and grasp it by its handle.
3. Insert the new module through the "Quick Access "module system opening. It may be
necessary to tilt the module forward before it will fit through the opening. This may seem awkward
at first, but it becomes as easy as changing a cartridge in a video game.
4. Align the module plug to be installed over the receptacle in the position you've chosen.
5. Slowly insert the module connector into the receptacle. Apply moderate pressure until you feel
the module is seated snugly.
6. Repeat steps 2 thru 5 for each module you are installing. When you have finished installing
modules, double check all modules to ensure they are still snug in their receptacles.
7. Align the "Quick Access" cover with the holes in the top of the amplifier cabinet and secure. If
your amp is plugged in and the Standby switch is set, your amp will automatically be turned on
into the "Standby" mode. Give it a minute or two to warm up completely, flip the switch to "On"
and you're ready to play.
*Note: Amplifier will not operate without the module access panel securely fastened. (This
depresses the safety shutoff switch.)
To remove:
1.Turn the "Quick Access" plate screws counter-clockwise. They will pop up.
2. Remove the plate. When this is done, it will automatically shut down the amp.
3. Looking down inside the amplifier, firmly grasp the module you want to replace by its handle
and lift slowly. When the module is free from its receptacle, continue to lift upward. You may have
to turn the module sideways to clear the module opening.
