Duke 155433P, Инструкция по установке, эксплуатации, комплектующим и обслуживанию

Страница: 6 / 24

6 of 24
Wiring diagrams are located on the inside of the motor
access panel, on the right side of the oven.
E. Ventilation
Proper ventilation is very important for the proper function
of your oven. A good ventilation system will allow the oven
to function properly as well as remove unwanted vapors.
Not venting the ovens properly can result in unsatisfactory
baking results as well as the possibility of damaging your
oven.
F. Oven Assembly
Before assembling and installing the oven, please check to
make sure that all necessary parts are present. In addition to
the oven itself, there will also be legs, feet or casters. (For
double sections, retaining clips, and miscellaneous
hardware.) Please check the interior of all oven sections for
the parts needed to assemble and install your oven(s).
Leg Attachment (in lieu of stand)
•
Once the oven has been removed from the
carton, lay it on its left side (the side without the
controls).
•
Hold the leg and align with the matching holes
in base and leg flange. Carefully start the 5/16
18 bolts, (avoid cross-threading), by turning
clockwise and tighten to the nearest full turn. A
total of (12) 15/16-18 X 3/4 bolts, flat washers
and lock washers are required to secure all legs.
•
Once legs are secured, add two (2) storage
shelves between the four (4) legs. Secure these
by using the 1/4-20 X 3/4 self-threading
screws. After completion, carefully lift the oven
to an upright position.
To level the unit, raise or lower the adjustable feet as
required.
G. Adjustments Associated with Installation
Each oven section and all its components parts have been
tested thoroughly and inspected before your oven was
shipped from the factory. However, it is sometimes
necessary to further test or adjust the oven once it has been
installed. Such adjustments are the responsibility of the
Dealer or Installer. These types of adjustments are not
considered defects, rather a normal and routine part of the
proper installation of the equipment.
These adjustments include but are not limited to:
•
adjustments and recalibration of the controller
•
adjustment to the doors, leveling
•
and tightening of fasteners.
No installation should be considered complete without
proper inspection and, if necessary, any adjustments by
qualified service or installation personnel.