Page 12
iQ Series AiM
™
Automation in Mind
,
Ultrasonic Power Supply User’s Manual
Dukane Manual Part No. 403-610-02
Continued from Previous Page
Automation Controlled Probe
System
1. Ground the generator chassis using the supplied
14-Gauge wire, and attach it to the grounding stud
PE:
A
in Figure 2-8.
2.
Recommended – Ground the probe support. This is a
user–supplied 14-Gauge wire. This is required if the
probe support does not have a good earth ground
through the machine.
3. Input Cable/Output Cable - Attach the automation
control cable from the user–supplied automation
equipment to the system input HD-26 connector, J5
on the I/O panel:
B
in Figure 2-8.
4. Attach the high voltage coaxial cable from the probe
to the ultrasound output connector J1:
C
in Figure 2-8.
5. Connect the AC power cord to the generator IEC
power inlet connector, and plug the other end into
an approved AC outlet:
D
in Figure 2-8.
Figure 2-8
Generator - Bottom View (Vertical Panel Mount Chassis)
C
ULTRASOUND
A
AC POWER ENTRY
D
PE
B
SYSTEM I/O
