24
2. Projecting an Image (Basic Operation)
❾
Turning off the Projector
To turn off the projector:
1. First, press the
(POWER) button on the projector
cabinet or the STANDBY button on the remote control.
The confirmation message will be displayed.
• The confirmation message displayed when the power
is turned off indicates the amount of CO
2
reduction this
session and lamp life remaining (
→
).
2. Secondly, press the ENTER button or press the
(POWER) or the STANDBY button again.
The lamp and the power are turned off and the cooling
fan stops to rotate, the projector goes into the STANDBY
MODE. When in standby mode, the POWER indicator
will light red and the STATUS indicator will turn off when
[NORMAL] is selected for [STANDBY MODE].
Power On
Steady blue light
Fan rotating
Standby
Blinking orange
light
Steady red light
3. Mount the lens cap.
Put the top side of the lens cap to the right position on the
cabinet and push in the bottom side. The stopper is secured
to the projector.
Stopper
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned off with the POWER button.
Be careful to handle the projector.
NOTE:
• While the POWER indicator is blinking blue in short cycles, the power cannot be turned off by using the power button.
• You cannot run off the power for 60 seconds immediately after turning it on and displaying an image.
• Wait for about 10 seconds to turn off the power after making adjustment or change on each setting and close its menu. If the
power is turned off during this period, the adjustment and change may be reset at default setting.
• Do not disconnect the power cord while the cooling fan remains to rotate. It may be cause of malfunction.
