7
VOICE MESSAGES RECORDING
Before use SINT-13 it is possible to customize the voice messages (
from 1 to 13
) used.
Open the cover to access to electronic board: there are 2 buttons, 4 LEDs (
green, yellow, blue and red
) and
one jumper which are used to program the functions.
Enter in “Messages recording” mode
1.
Close the jumper
JP1
on pins
B
and
C
.
As soon as the pins are closed:
LD1
(
GREEN
) lights solid on
LD2
blinks one time then stay solid on: SINT-13 is ready to record the Voice Message 1.
2.
Now it is possible to record the voice message:
Hold down the
P2
button until the
LD2
(
BLUE
) LED lights on.
Release
P2
and talk about at 10 cm from microphone (
MIC
).
To stop the recording before the max 15 seconds available, press briefly
P2
.
3.
To move to next message position:
Press briefly
P1
. As confirm the
LD2
LED blinks as many times as the number of the Voice
Message, then stay solid on
(
Example: 3 blinks = message n° 3
).
4.
To play the voice message in a certain position: press briefly the
P2
(
LD3
BLUE it blinks during the
play
) button.
Proceed for all the messages in the same way.
Exit from “Messages recording” mode:
open the jumper
JP2
.
