Duco IQ-unit, Быстрый старт

Страница: 94 / 112

94
ENGLISH
6B.
Installing components
Go through the following steps to pair components with the IQ-unit.
1
Activate ‘Installer mode’ by tapping ‘INST’ on the IQ-unit. The LED
will flash green rapidly.
2
For zonally controlled systems only: Tap once on the feed-through
component to pair it with the IQ-unit so the LED flashes green
slowly. Tap again so the LED starts to flash rapidly. Underlying
components can now be added in this zone.
3
Add control components* by tapping once on the component to be
paired. The LED will start to flash green rapidly.
4
Add any window ventilators* by tapping once on the component to
be paired. The LED will flash green slowly.
5
For zonally controlled systems only: Repeat steps
3
and
4
until all remaining components in the current zone are paired. Exit
the current zone next by tapping the feed-through component from
step
2
once more. The LED will flash green slowly again.
6
For zonally controlled systems only: Repeat steps
2
to
5
inclusive for the remaining zones.
7
Once all components have been paired, ‘Installer mode’ can be
deactivated by tapping ‘INST’ on the IQ-unit.
Please refer to the manual with the components for more detailed
information.
* NB: only RF components can be paired under an Intelli Air Valve.