Ducati DBC 3300M, Руководство пользователя

Страница: 43 / 56

43
English
Owner’s manual
DBC 3300M
BRUSHCUTTER 4 IN 1
43
14. MAINTENANCE&CARE
Use only original manufacturer´s replacement
parts, accessories and attachments. Failure
to do so can cause possible injury, poor
performance and may void your warranty.
• The cutting attachment must not rotate in
idle mode.If this requirement is not satisfied,-
the cluth has to be adjusted or the machine
needs an urgent maintenance by a qualified
technician.
• You may make adjustments and repairs des-
cribed here. For other repairs, have the trimmer
serviced by an authorized service agent.
• Consequences of improper maintenance may
include excess carbon deposits resulting in
loss of performance and discharge of black oily
residue dripping from the muffler.
• Make sure all guards, straps, deflectors and
handles are properly and securely attached to
avoid the risk of personal injury.
Exhaust port and silencer
• Depending on the type of fuel used,the type
and amount of oil used, and/or your operating
conditions, the exhaust port and silencer may
become blocked with carbon deposits.lf you
notice a power loss with your petrolpowered
tool.a qualified service technician will need to
remove these deposits to restore performance.
Air filter
• Accumulated dust in the air filter will reduce
engine efficiency. Increase fuel consumption
and allow abrasive particles to pass into the
engine. Remove the air filter as often as neces-
sary to maintain in a clean condition.
• Light surface dust can readily be removed
by tapping the filter. Heavy deposits should be
washed out in suitable solvent.
• Remove filter cover by push the button.
If the starter rope is pulled repeatedly with the
choke on, it may flood the engine and make
starting difficult.
If you have flooded the engine, remove the
spark plug and gently pull the handle on the
starter rope to eliminate any excess fuel; then
dry the spark plug electrodes and replace it
on the engine.
Stopping the engine
• Release the throttle trigger and allow the
engine to run idle for a few seconds.
• Move switch to STOP position.