XCAM100
What's Inside The Box
1.
Product Sheet
2. X
CAM100 Camera w/ Adjustable Mount
3.
Power Cable w/ Fuse, Video Cable, 2 Mounting
Screws and Foam Rubber Mounting Pad
Mounting the camera
Look for a location that will give you the best view behind the vehicle.This should not be
directly next to or under a reverse/backup lamp as it may blind the camera at night.Avoid
license plate lamps as well as they may blind the camera at night. Before drilling,
determine the best way to run the power wires to the reverse lights & the extension cable
through the car.Insure that your route will not interfere with any safety equipment,trunk
release or other items in the vehicle.Look for wires, sensors,double metal,anything that
could cause a problem or damage.The camera should lay flat against the mounting surface
for proper installation.
1.Use the included hardware to secure the camera to the vehicle.DO NOT OVERTIGHTEN the hardware.
2.Follow ONE of the following wiring options.
Oprion 1:
Connect camera power wire to the vehicle's reverse lamp:
a)Locate the reverse lamp in the tail light assembly.
b)Attach the red wire to the positive 12 volt wire from the reverse lamp.Use a crimp connector or soldering tool to ensure
connection is secure. Once this connection is complete,note that the red power wire that is located on either end of the video
RCA cable will not be needed. The bare wire at the end of each wire lead should be capped or taped off to prevent potential
power interruption.
c)Attach the black wire to ground(-).
d)Run video cable to the location of the receiver or montior(not included).Connect one yellow RCA end of the video cable to
the camera and connect the other end of the yellow RCA cable to the video source(receiver/monitor).
Option 2:
Connect camera power wire to receiver/monitor power:
a)From camera location,connect red power wire from power cable to red power wire from one end of the video cable.Use a
crimp connector or soldering tool to ensure connection is secure.
b)Attach the black wire to ground.
c)Run video cable to the location of the receiver or monitor(not included).Connect not yellow RCA end of the video cable to the
camera and connect the other end of the yellow RCA cable to the video source(receiver/monitor).
d)From video source(receiver/monitor) location,connect red power wire from end of the video cable to the reverse wire lead
located on the video source(receiver/monitor).
Camera Specifications
Image Sensor: CMOS,7440H
Power: 12V DC,Negative Ground
Power Consumption:
＜
1 Watt
Effective Pixels: 733H × 493V
Video Format: NTSC
Lux:
＜
0.5
White Balance: Auto
Viewing Angle: 170 Degrees
IP Rating: IP67
Operating Temperature: -30
℃
~ +70
℃
Camera Body: Zince Alloy
