18
d)
Replacing the compressor’s filter
The unit is equipped with a filter that removes potential impurities from the compressor’s intake air.
On a regular basis, or if the unit loses its effectiveness (increased aerosol therapy session time), check the
filter and change it if it is soiled. To carry out a check or a replacement, lift the cap for the filter holder. If
needed, remove the filter using tweezers.
1. Place the unit on its side
2. Remove the cap for the filter
holder
3. Change the filter if needed
5.
Application
a)
Preparing accessories
Follow the exact order of the following steps.
1. Insert the M selector into the upper
part of the nebulizer by lining it up with
the deflector
2. Connect the atomizer to the
reservoir
3. Pour the solution into
the reservoir
6. Connect the pressure tube
under the nebulizer
5. Connect the mouth piece or, if not, the mask to
the nebulizer
4. Fasten the top of the
nebulizer to the reservoir
b)
Preparing the unit
Follow the exact order of the following steps.
1. Connect the tube to the
unit
2. Connect the unit’s plug
3. Press the “on/off”
button
NOTE:
Connect the nebulizer to the unit before turning it on.
Deflector
