DT SWISS RATCHET EXP, Техническое руководство

Страница: 11 / 23

Ratchet EXP - Technical Manual 11
2.7 DISMOUNTING THE BEARING FROM THE THREADED RATCHET
1. Put the threaded ratchet with the bearing
into the mounting / dismounting tool.
→ The toothing of the threaded ratchet
must face upwards.
→ Put the ratchet on the side of the tool
with the fitting diameter. The ratchet
may only move minimally in tool.
HXTXXX00N6106S
2. Slide the axle with its short end through the
bearing.
3. Use a plastic hammer to knock the ball
bearing out of the ratchet with light hammer
strokes.
4. Remove the ratchet and the bearing from
the tool.