* Public Address System Intelligent Public Address System
17
listed.
4
—
2.3
After finding it again, if the list is still different from the actual configuration, you should turn off the
power according to the operating procedures for powering off, and check if the corresponding modules
are installed in place, and then restart it to check. If there is still a problem, please contact with the
distributor.
4
—
2.4
Please note: function modules should be inserted or pulled out when the power is disconnected!
4
—
3
Comprehensive setting
4
—
3.1
Click “system configuration” button to enter the system’s comprehensive setting interface.
4
—
3.2
There are 9 items to check. To be convenient for operation, it is recommended to select the following
items (click the box to check it):
4
—
4
Sound source setting
4
—
4.1
Click “
sound source setting
” button to enter sound source naming or other sound source setting
interface.
4
—
4.2
Click the inverted triangle drop-down symbol at the right side of the sound sources with serial
numbers, and select a suitable name (i.e. a name consistent with the device matched and connected
with the sound source module’s input port) in the drop-down list box.
4
—
4.3
After they are selected one by one, click “
confirm
” button.
4
—
5
Partition operation and setting
The partition operation is to distribute different sound sources to different broadcasting partitions, and adjust the
volume of the sound source during distribution.
4
—
5.1
Click a sound source button on the main interface to let it shine. If the clicked one is the inner DSPPA
or CD sound source, then you can immediately start to play or pop up the program play interface
(depending on 4-3 comprehensive setting), and please see 4-14 for the operations of play interface; if
the clicked one is the external sound sources, then you need to operate and control the sound source
device to let it play sound. When “
use automatic monitoring mode
” is checked in the comprehensive
setting (see 4-3), then the sound of this sound source can be heard through the monitor speaker.
4
—
5.2
Then click the partition button needing to use this sound source, and the partition button will
immediately display the name of this sound source, then the sound source is distributed to the assigned
partition. You can continuously click more than one partition buttons, and distribute the sound source
to several partitions.
4
—
5.3
After finishing distributing a sound source to the partition, you can click another sound source to let it
shine, and repeat the above steps to distribute the current sound source to another partitions. All sound
sources are interlocked, and at any time, only one sound source button can be pressed. The system will
not distribute two or more sound sources to a partition at the same time either, to avoid crosstalking.
4
—
5.4
After the sound sources are combined with and distributed to the partitions, you should click again the
sound buttons that are still shining, to let it bounce (turn dark), then you can open or close the partition
buttons. Click the partition buttons that do not shine to let it shine (that is to open the partition); and
click the partition buttons shined to let it turn dark (that is to close the partition). Please note that when
opening or closing the partitions, if a sound source button does not bounce, it will be wrongly
Use automatic monitoring mode;
Open the corresponding players when clicking the “
DSPPA sound source
” or “
inner CD
”
button;
The sound source button will automatically bounce after no operations for X seconds (let X=30).
