User Manual
AUBION X.8
27/29
9.4 Connection logic and status change
The following overview shows all status changes in the connection logic of the
X.8
.
9.5 Configurations in
X.8
GUI vs.
X.8
device
The following table compares possibilities of configuration in the X.8 GUI and at the device:
X.8
GUI
X.8
device
Connection status
Device List, System Tray
- no status display -
Device information
Service name, IP/MAC address,
HW, boot loader and firmware
ve sampling rate in bar at
bottom
Serial number, MAC address on the
label on the bottom of the device
Curent headphone channel
Activated channel button
Activated channel button
Signal level
Per channel with 0.1dB precision
3-level per channel:
·
< -50 dBFS
rms
: LED off
·
³
-3 dBFS
rms
: LED red
·
other: LED green
Gain settings
Line-Out reference level, Mic/Line-In
and Line-Out gains
Mic/Line-In and Line-Out gains
Mic-/Line-In switchover
Per channel 1 to 4
- no configuration -
Phantom supply
Per channel 1 to 4
- no configuration -
Mute Line-Out
One button for Mute-On/Off of the
Line-Out channels 1-2.
One button for Mute-On/Off of the
Line-Out channels 1-2.
Status display on LED in button (on
= Mute-on Out 1-2, off = Mute off
Out 1-2 )
In 7/8 input selection
“Line In 7/8” and “S/PDIF In 7/8”
selection
- no configuration -
Status display on LED with rear
S/PDIF-In/Out-RCAs (on = In 7-8 –
S/PDIF-In, off = In 7 - 8 – Line-In)
Master
“Master”, “Auto-Master” or “Slave
In 7/8” selection
- no configuration -
Status display on LED with rear
S/PDIF-In/Out-RCAs (on = S/PDIF-
In Slave, off = local Master)
Advanced settings and device
information
IO latency, device statistics,
firmware update
- none -
