D E E P S E A E L E C T R O N I C S
D S E 9 7 0 1 & D S E 9 7 0 2 B A T T E R Y C H A R G E R
I N S T A L L A T I O N I N S T R U C T I O N S
053-170
ISSUE 1
DANGER OF DEATH
:
LIVE PARTS exist within the Battery Charger
enclosure. The enclosure cover must not be removed.
Installation
The DSE9701 (24V 5A) & DSE9702 (12V 5A) battery chargers are designed to be mounted
vertically within a control panel, on the panel DIN rail utilising the integral mounts or on a chassis
utilising the mounting holes. For dimension and mounting details, see overleaf.
DSE battery chargers are
fit-and-forget.
They are permanently connected to the supply and the
load, with no requirement to disable the charger during times of heavy load (such as engine
cranking) or when in parallel with a charging alternator.
Battery Suitability
The charger is factory set by DSE to suit Lead Acid batteries but can be adjusted at the time of
ordering to suit other battery types.
Care must be taken to ensure the batteries connected to the charger are of the correct
‘technology’ to suit the setting of the charger.
Indications
The Battery Chargers feature an LED indicator(s) to show the battery charger
Status.
(Refer to DSE publication: 057-085 DSE9xxx Series Operator Manual for further information)
Boost Mode
Boost mode is operated by connecting the
BOOST
terminals together for instance with an
external switch or timer circuit. This will raise the battery charger floating voltage by 0.8V DC.
Typical Wiring Diagram
NOTE : This document is intended as a ‘quick start’ guide only. For full
operating instructions and specifications, refer to DSE publication: 057-085
DSE9xxx Series Operator Manual.
Connection Type
Screw Terminal,
Rising Clamp,
No Internal Spring
Min Cable Size
0.5mm² (AW G 20)
Max Cable Size
2.5mm² (AW G 14)
DSE9701 AC Fuse
(230 V AC Supply)
2.0 A Anti-Surge
DSE9701 AC Fuse
(110 V AC Supply)
3.5 A Anti-Surge
DSE9702 AC Fuse
(230 V AC Supply)
1.0 A Anti-Surge
DSE9702 AC Fuse
(110 V AC Supply)
2.0 A Anti-Surge