12
4.8 Setting Up the PC5502Z2 to Sound Alarms Locally
You can set up the PC5502Z2 so that if an alarm occurs, the keypad will sound the alarm
locally for a programmed amount of time before passing the alarm condition on to the
main panel. If an alarm occurs on a PC5502Z2, the following will occur:
• PC5502Z2 will sound an alarm tone on the keypad buzzer and begin counting down
the local alarm duration timer.
• If the alarm is false, a user can cancel the local alarm by entering their access code on
the keypad.
• Once the local alarm duration timer countdown ends, the PC5502Z2 will cause an alarm
condition on its corresponding keypad zone on the main panel. This panel keypad zone
will be instantly violated and then restored.
• The main panel will then sound a general alarm, and (if programmed) transmit the alarm
information to the central station. When the main panel bell is sounding, the PC5502Z2
cannot be armed.
You can program the amount of time the alarm will sound locally in [50] Local Alarm
Duration Timer. Program an amount of time from 001 to 255 seconds. If you program
000 seconds, the PC5502Z2 will not sound a local alarm, and will pass alarm informa-
tion on to the panel immediately.
To program the Local Alarm Duration Timer:
1. At the PC5502Z2 keypad, enter [*][8][Installer’s Code]
2. Enter [50].
3. Enter a 3-digit number for the number of seconds.
4. If you want, you can now enter another programming section; or to exit program-
ming, press [#].
4.9 Setting Up Door Chime Options
You can set up each PC5502Z2 zone to activate the door chime feature. By default, the
door chime feature is turned on for both zones. Users will also be able to turn the door
chime feature on and off using [*][4], however sections [41] and/or [42] must be turned
on first.
To turn off the door chime for a zone:
1. At the PC5502Z2 keypad, enter [*][8][Installer’s Code]
2. Enter [41] for zone 1, or [42] for zone 2.
3. To turn the door chime on or off for the zone, press [1].
4. When the option is set correctly, press [#].
5. If you want, you can now enter another programming section; or to exit program-
ming, press [#].
