owner’s manual
instructions for functions and controls
electrical connection
specifications
WE LIkE IT LOUD
Low Level Output -
A daisy chain output for connection to another amplifier with a
low level input using only a single RCA output from the source (head unit).
Low Level Input -
For connection to any source (head unit) with a low level output
this is your RCA output from the source (head unit).
GAIN
- Knob for volume adjustment.
LPF
- Low pass frequency adjusting knob, the frequency range from 40Hz
to 180Hz.
SUBSONIC
- Subsonic frequency adjusting knob, the frequency ranges from 17Hz
to 50Hz.
BASS FREQ
- The Boost range from30Hz to 80Hz..
BASS BOOST
-The Boost range from 0dB to 12dB.
REMOTE CONTROLLER OUTLET
- To be connected with the remote controller,
which help to boost the gain. Please turn the knob of volume to be maximum before
using the remote.
INDICATOR LED
- When the amplifier is operating correctly the LED of G-power
will show as green. When the amplifier is in protection mode the LED of R-protect
will show as red.
REMOTE CONTROLLER
- Volume level knob, the Gain ranges from 0.2V to + 6V.
SPEAKER
- Speaker connecting terminal.
+12V
- Anode of power connection terminals. Connect to the anode of car battery.
REM
-
Terminal to be connected with Remote cable, which comes from the source
and which controls the amplifier switching on. Applied voltage must be between 10
and 15VDC.
GND
- Ground terminal. Connect to the car chassis. Keep the length of the ground
cable to a minimum.
MODEL GEN-X6000.1D
RMS Power @ 14.4VDC
Power @ 4 ohms
700W x 1
Power @ 2 ohms
1200W x 1
Power @ 1 ohms
2000W x 1
Minimum Speaker Impedance
1 Ohm
THD Distortion
0.08%
Input Sensitivity
0.2V~+6V
Input Impedance
10K
Signal - To - Noise Ratio
98dB
Remote Gain Control
0.2V~+6V
Crossover Network
Low Pass Filter
40Hz~180Hz
Bass Boost
0dB to + 12dB
Subsonic 17Hz~50Hz
Bass Frequency
30Hz~80hz
Size L x W x H
380 x 190 x 60 mm
gEN-X6000.1d
1
10
11
2
3
4
5
6
7
8
9
