DryBell Vibe Machine V-2, Руководство по настройкам

Страница: 10 / 18

DryBell Guitar Effects www.drybell.com Vibe Machine V-2, Options User’s manual, rev.1.4. 09/2018
BACK TO CONTENTS
DryBell
Doc. No. DM0958/ Page 10
SETUP
MENU
1/2
SETUP
MENU
(POSITIONS)
SETUP MODE
FUNCTION
NAME
DESCRIPTION, for what can be
used?
PARAMETER POSITIONS
AROUND THE SPEED POT
RESET TO
DEFAULT
FACTORY
SETTINGS
MENU
1
6 (S6)
CANCEL DELAY
ADJUSTMENT
(only when
using exp.
pedal)
When an exp. pedal is used to
activate Cancel Mode, this
mode is activated by putting
the exp. pedal in the heel down
position (by default) but it is
not activated momentarily.
Cancel Mode has a slight delay
between putting the pedal in
heel down position and
activating the Cancel Mode. It
is developed this way so the
user can’t accidentally go to
Cancel Mode while using the
expression pedal. When the
exp. pedal goes to heel down
position, the system LED will
first light ORANGE, and after
this brief delay it will go to RED
where the pedal is then in
Cancel Mode.
Rotate the speed pot for
desired delay. At MIN
position Cancel delay is 0,
linear increasing to 1
second at MAX position.
0.5 SEC
MENU
1
7 (X7)
TAP TEMPO
MULTIPLIER
SELECTION FOR
T10 POSITION
There are 3 tap tempo
multiplier pre-sets on the
speed pot positions T8 (x1), T9
(x2) and T10 when the V-2
pedal is used in Tap Tempo
mode.
In this setup menu, the T10
multiplier can be customized by
user. E1 : x0.5
E2 : x1
E3 : x1.5
S4 : x2
S5 : x2.5
S6 : x3
X7 : x3.5
T8 : x4
T9 : x4.5
T10 : x5
x3
MENU
1
8 (T8)
INTERNAL
INCANDESCENT
LIGHT BULB
LAMP ON OR
OFF WHEN THE
PEDAL IS IN
BYPASS
Is it possible to turn the
internal photocell’s
incandescent light bulb off
when the pedal is off (in
bypass) in order to prolong the
lamp’s life.
The side effect is that the lamp
needs to reach it’s dynamic
working state, so for a short
while (orange LED lights) after
turning the pedal on the Vibe
Machine will behave as if it is
coming out of Cancel Mode
because the driver, the lamp
and the photocells have to
start working before the proper
vibe effect can occur, Also
check chapter 10.
E1, E2, E3, S4, S5:
INTERNAL LAMP STAYS
ON WHEN THE PEDAL IS
SWITCHED OFF
S6, X7, T8, T9, T10:
INTERNAL LAMP WILL
TURN OFF WITH THE
PEDAL
INTERNAL
LAMP STAYS
ON WHEN THE
PEDAL IS
SWITCHED OFF
MENU
1
9 (T9)
SYSTEM LED ON
OR OFF WHEN
THE PEDAL IS IN
BYPASS
If you don’t want the system
LED blinking when the pedal is
in bypass, you can switch off
the system LED.
E1, E2, E3:
THE SYSTEM LED WORKS
ALWAYS
S4, S5, S6, X7:
THE SYSTEM LED IS OFF
WHEN THE PEDAL IS OFF
T8, T9, T10:
THE SYSTEM LED IS OFF
WHEN THE PEDAL IS OFF
EXCEPT IF CANCEL IS
ACTIVE
THE SYSTEM
LED WORKS
ALWAYS