Operation (CME)
5-1
5. Operation (CME)
Purging Air from the “HTF” Circulation System
•
Verify that the primary circulation lines are
connected to a distribution manifold.
•
Complete the connection for one “heat exchanger
loop” or “portable heat exchanger”. This will close
the circulation loop and allow circulation.
•
Verify that the “supply” and “return” isolation
valves
figure 15
(1-1) and the isolation valves at
both ends of the primary circulation lines (hard
connection to the manifold) are in the “Open”
position.
•
The automatic air vent
figure 16
(2-1) valve cap
figure
16
(2-2) should not need adjustment. The valve cap
should be opened 1 ½ turns (counter clockwise) from
fully closed to allow air to escape from “HTF”
•
Toggle the pump switch
figure 17
(3-1) to the “On” (up)
position and run the pump. This will release the air
from the system.
Figure 15-Supply & Return Isolation Vale in
the Open Position
Figure 16-Automatic Air Vent
Figure 17-Pump, Water & Flow Reverser
Switch
Содержание 600 GTS Series
