Setup (CME)
Heat Transfer Fluid Specifications
•
The system is shipped with pre-mixed “HTF”, made up of 50% “Dowfrost ® HTF”
or “Boss Chill PG” and 50% water*, by weight – freeze protection down to -28°F (-
33°C).
•
The “glycol/water mixture chart” below will provide you with more information on
the proper mixture for your area.
•
“Dowfrost ® HTF” or “Boss Chill PG” must be used. The pure “Dowfrost ® HTF”
or “Boss Chill PG” heat transfer fluid used in the system is made of a blend of 95-
97% Propylene glycol, <5% Dipotassium phosphate and deionized water (see Safety
Concerns section – MSDS sheets) for additional information.
•
Soft water with a pH level (#7) must be used.
*CAUTION! Whenever coupling or uncoupling quick couplers, make sure that the
isolation valves are closed and the pump is off. Failure to do so may put you at risk of
injury from eye and/or skin exposure to hot glycol.*
Figure 11- Glycol/Water Mixture Chart
Fuel
•
Only clean #1 or #2 diesel fuel or light heating oil is suitable for use in the system.
•
The “central heating module” comes equipped with its own tank, so there are no fuel
line hookups required.
•
The fuel system utilizes a two-pipe system to ensure efficient fuel supply to the
burner.
Contact your local fuel supplier to inform them of the requirements.
4-3
Содержание 600 GTS Series
