Dru Maestro 60/2 Tall RCH, Руководство по установке

Страница: 18 / 68

I nst allation manual
1 8
7.2.3 Placing the appliance control unit under the platform
If, in case of a situation with a platform, there is no room for the control hatch, the appliance control unit must be placed
directly under the platform using the 'electricity protective cabinet'.
3
- It is not permitted to mount the appliance control unit to the appliance.
- Disassemble the appliance control unit from the transport bracket.
- Remove the transport bracket and dispose of it as required.
3
- There is 230V of mains voltage on the appliance control unit.
- Avoid kinks in the pipes.
- The electricity protective cabinet and the appliance control unit should always be placed indoors on a dry location.
When placing the appliance control unit under the platform using the protective cabinet, proceed as follows (see fig 7-7).
1
Mount the attachment bracket of the protective cabinet both against the back wall and bottom side of the platform,
using suitable fastening materials (Step 1).
1
Disassemble the appliance control unit from the appliance and attach it to the fastening bracket of the protective cabinet
(Step 2).
1
Connect the gas pipe as described in section 6.3 (Step 3).
1
Position the gas pipe, flexible gas pipe and cables on the recesses in the fastening bracket of the protective cabinet
intended for that purpose and fasten them with tie-wraps (Step 4).
3
- Ensure the cables of the ionization and ignition pins are lying free from metal parts as much as possible and are lying
fully free from signal and voltage cables.
- In case of damage to the mains cord, it should be removed immediately and replaced by a cord of the same type.
1
Place the data plate of the appliance in the bracket of the protective hood (Step 5).
1
Hook the protective hood into the fastening bracket and fasten it with the self-tapping screw (Step 6).