Dru 0063CT3681, Руководство по установке

Страница: 7 / 48

5. SAFETY
5.1 General
3
- Observe the generally applicable regulations and precautions/safety instructions in this manual.
- First check that the technical execution of the appliance to be installed is correct (see table 4-1).
- Read this manual carefully to ensure the proper and safe installation of the appliance.
- Observe the regulations/instructions in this manual.
5.2 Regulations
Please install the appliance in accordance with the applicable national, local and constructional (installation) regulations.
5.3 Safety instructions
Carefully observe the following precautions/safety instructions:
3
The appliance may only be installed and maintained by recognised installers who are skilled in the field of gas heating
and electricity.
3
Do not make any changes to the appliance.
3
When installing a built-in appliance:
- Use non-combustible and heat-resistant materials for the chimney breast, including the top of the chimney breast and
the material in the chimney breast, such as the floor under the appliance and the back wall against which the appliance
will be placed. For this you can use both sheet material and stone-like materials.
- Take sufficient measures to prevent temperatures of a wall behind the chimney breast becoming too high, including
the materials and/or objects behind the wall.
- Take the minimum required internal dimensions of the chimney breast into account. These are for the benefit of safety
and for the prevention of excess heat accumulation in the chimney breast.
- Vent the chimney breast by means of the ventilation holes (see table 4-1). These are essential for ensuring safety and
for the prevention of excess heat accumulation in the chimney breast.
- Use heat resistant electrical connectors.
- Place heat-resistant electrical wiring away from the appliance and as low as possible in the chimney breast. This has to
do with the temperature development in the chimney breast.
- Only use the flue gas discharge / combustion air supply system (concentric system) supplied by DRU.
3
When installing a free-standing appliance: place the appliance at the indicated minimum distance from the back wall, as
indicated further down in the text.
3
Do not cover the appliance and/or do not wrap it in an insulation blanket or any other material.
3
Keep combustible objects and/or materials outside the appliance's radiation range (see table 4-1).
3
Only use the accompanying set, such as the wood or pebble set, and place it exactly as described.
3
Leave space around the ionisation pin and spark electrode and never place glow material around these pins.
3
Make sure there is no dirt in gas pipes and connections.
3
Place a gas tap in accordance with applicable regulations.
3
Check the complete installation for gas tightness prior to commissioning.
3
Prevent the explosion hatch(es) on the top of the appliance (if present) from getting clogged and check that they
properly fit on the sealing surface, before the appliance is built in.
3
Do not ignite the appliance until it is fully installed when it comes to the gas connections, discharge system and electrical
components.
3
Do not use the appliance when a pane is broken and/or cracked, until it has been replaced.
3
The appliance was designed for atmospheric and heating purposes. This means that all visible surfaces, including the
glass pane, can become hotter than 100C°. It is recommended to always place a protective grating in front of the
appliance when there are children, elderly people or handicapped persons in the same room as the appliance.
If it is possible that vulnerable people are regularly present in the room with no supervision, a fixed guard should be
mounted around the appliance.
I nst allation manual
7