Dru 0063CT3681, Руководство по установке

Страница: 28 / 48

I nst allation manual
2 8
8.2 Adjusting the appliance
The appliance has to be set in such a way that it works correctly in combination with the discharge system. For this
purpose, it is possible to place a restrictor slide. The conditions for application with wall and roof terminal are indicated in
tables 7-3 to 7-5.
The restrictor slide is supplied separately. It is mounted as follows (see fig. 8-3):
1
Open the glass pane (see section 8.1.1)
1
Remove the upper decor panel (1).
1
Unscrew the 2 pre-mounted self-tapping screws from the combustion chamber and place the restrictor slide. The
restrictor slide partly falls over the hole of the exhaust pipe, do not yet tighten the self-tapping screws (2).
3
When being connected, the arrow on the restrictor slide should point downwards.
1
Adjust the position of the restrictor slide on the basis of situations B, C and D (see table 7-4). The letter for the position on
the restrictor slide corresponds with the letter of the situation (see table 7-3 or 7-5).
1
Make sure that the point of the triangle that belongs to the position required is exactly aligned with the centre of the
self-tapping screw and tighten the 2 self-tapping screws (3).
1
Place back the upper decor plate (4).
3
Make sure the decor plates connect properly. Gaps between the decor plates result in an incorrect air flow and have a
negative effect on the flame picture. (5).
3
4
5
2
1
38C-2603
8-3