Dru 0063CT3681, Руководство по установке

Страница: 20 / 48

7.3.3 Wall terminal (C11)
When using a wall terminal (C11), the following applies:
The construction of the chosen system has to be allowed.
1
Check that the vertical pipe length falls between the minimum and maximum lengths (see table 7-5).
1
Check that the horizontal pipe length (wall terminal excluded) falls within the minimum and maximum length (see table
7-5).
2
In the horizontal section, 1 bend of 90° may be included. This bend counts for 2 metres. This means that the maximum
allowed length is reduced by 2 metres. A 45° bend counts for 1 metre.
1
Determine the correct adjustment of the appliance (see table 7-5).
1
Adjust the appliance correctly with, for instance, a restrictor slide and an air inlet guide (see section 8.2).
The rosette of the wall terminal is too small to seal the opening in case of passage through combustible material. That is
why a heat-resistant intermediate plate of sufficient size should first be mounted to the wall. Then, the rosette is
mounted on the intermediate sheet.
3
When using a wall terminal, place the terminal with a downward slope of 1 cm / metre towards the outside, in order to
prevent rain water from raining in.
I nst allation manual
2 0
1 - 4m
≤ 2,5m
0 - 0,5m
38C-744ZZB
1x90°
1 - 4m
0 - 0,5m
38C-744ZZA
1x90°
Table 7-5A Table 7-5B
Setting
Restrictor slide
Apply
x
- Only use a 150/100 mm concentric system, including wall
terminal.
- Factory setting: restrictor slide is supplied separately and
must not be placed. - Use a concentric system of 150/100mm for the vertical
length including bend.
- Directly after the bend or up to maximum 0.5 m after the
bend, enlarge the concentric system to 200/130 mm
including wall terminal.
- Factory setting: restrictor slide is supplied separately and
must not be placed
Setting
Restrictor slide
Apply
x