Drone Rescue Systems DRS-M300, Руководство пользователя

Страница: 16 / 54

Parachute Manual DRS-M300 v2.3-EN (2022-08-10)
©2022 Drone Rescue Systems GmbH 15/26
Take a cutter knife and cut down along the
two orange dashed lines (in line with the
original recess). Afterwards cut horizontally
between the orange lines about 1cm above
ground and remove the plastic.
Take a cutter knife and cut down along the
two blue lines. Afterwards cut horizontally at
the same level as the purple marking and
remove the plastic.
Take a cutter knife and cut down along the
two green lines. The longer continuous line
should be twice as long as the shorter one.
Afterwards cut horizontally at the same level
as the yellow marking and remove the
plastic.
The UAV + DRS M300 connector and cord box should now fit in the case.
Configure the M300
5.5.1 Configure Onboard SDK in DJI Assistant Application
Onboard SDK is used to switch off the UAV motors before the parachute is deployed.
•
Remove the container from the UAV.
•
Turn the UAV on.
•
Connect the UAV to a PC using a USB-cable and start DJI Assistant 2 to configure
the API (see DJI M300 user manual for details).
•
Select " Onboard SDK " on the left.
•
Tick the " Enable API Control " box on the top left.