Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Return the drone to the landing zone and land. During this process pay particular care
to watch for any other inflight fires.
6.2.6 Perform Post Flight Inspection
Perform Post Flight Inspection
:
Complete
Perform the steps in the post flight inspection in Section 4.5.
6.3 Stuck Ignition Sphere After Landing Checklist
6.3.1 Remove Needle Assemblies
Remove Needle Assemblies
:
Needles Removed
Remove the needle assemblies (Section 4.1.19). This will ensure that no antifreeze can
be injected into the ignition sphere.
6.3.2 Trigger Dropper Emergency Ejection
Trigger Dropper Emergency Ejection
:
Both Rotated Clockwise, Ejected
Rotate both dials fully clockwise within 2 seconds of each other to trigger the emergency
release as shown in Figure 34. Or, use the Emg. Release button in the App to trigger an
emergency release.
6.3.3 Battery Disconnect
Battery Disconnect
:
Disconnected
Unplug the power from Ignis (Figure 18).
6.3.4 Manually Remove Stuck Ignition Sphere
Manually Remove Stuck Ignition Sphere
:
Removed
Manually remove the stuck ignition sphere. Proceed to the post-flight inspection (Sec-
tion 4.5).
Last Updated March 12, 2020
Page 60
