Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
6.1.5 Perform Post Flight Inspection
Perform Post Flight Inspection
:
Complete
Perform the steps in the post flight inspection in Section 4.5.
6.2 In-Flight Fire Checklist
6.2.1 Check for In-Flight Fire
Check for In-Flight Fire
:
Fire Suspected
Check for abnormally high Ignis temperature, or use the camera to look for smoke or
flames coming out of Ignis. If a fire is suspected, continue this checklist. If not, continue
with regular operations (if applicable) or return to land as soon as it is safe to do so.
6.2.2 Disarm Ignis
Disarm Ignis
:
Disarmed
Move S3 on the control bar into the disarmed position (down and away from the user).
This will automatically cause Ignis to stop dropping.
6.2.3 Fly Over Safe Ignition Area
Fly Over Safe Ignition Area
:
Over Safe Ignition Area
Fly over an area where it is safe for there to be a ground fire to prevent unintended
ignition of other areas.
6.2.4 Trigger Dropper Emergency Ejection
Trigger Dropper Emergency Ejection
:
Both Rotated Clockwise, Ejected
Rotate both dials fully clockwise within 2 seconds of each other to trigger the emergency
release as shown in Figure 34. Or, use the Emg. Release button in the App to trigger an
emergency release.
This will cause the Dropper to be ejected and dropped from the Hopper, preventing the
spreading of any fire to the Hopper or drone.
6.2.5 Return Drone to Landing Zone and Land
Return Drone to Landing Zone and Land
:
Landed
Last Updated March 12, 2020
Page 59
