Drive Medical Bonsai OM-812CE, Информация о продукте и инструкции

Страница: 6 / 124

Prevent water or any other liquid substances from entering the unit.
Prevent dust, lint or any small particles from entering the unit, as these may degrade performance or cause oxygen leaks.
Do not expose the unit to extreme temperatures or heat sources such as fireplaces and radiant heaters.
Do not use humidifier bottles.
provider for more information about carry bags.
INTRODUCTION
SAVE THESE INSTRUCTIONS
CAUTION: Caution indicates a potentially hazardous situation which, if not avoided, may result in property
damage or minor injury or both.
•
•
•
•
•
•
•
•
•
•
•
•
•
Post-Valve Cylinder
FIGURE A
Toggle
Parallel Holes
on the
Post Valve
This manual provides information necessary to operate the Bonsai pneumatic oxygen
conserver with built-in regulator. The Bonsai can be used with a CGA 870 post-valve
cylinder [see Fig. A] at home or away from home to provide your specific oxygen
requirements.
is factory preset at 2 LPM.
TCh igh eck tening only for le byak hand s shou . The ld be use p of erforme a tool d to be tigh fore ten each u the knob may dam se. age the unit.
To help prevent possible damage to the unit and to maintain its cleanliness, kee p the OM-812CE pneumatic oxygen
conserver in a carrying bag. Several bags are available for use with different cylinder sizes and configurations: contact
your Home Care
NOTE: The OM-81 2CE Pneumatic Oxygen Conserver will be referred to as
the Bonsai in the remainder of the guide.
Do not use if leaking or damaged.
Refer repairs to authorized service personnel.
Do not use the flow outlet for driving any medical equipment.
This product contains natural rubber latex (oxygen pressure gauge rubber guard) which may cause allergic reactions.
Oxygen supplied by this equipment is supplemental only and is not intended for life support applications.
The OM-
CE should not be used to supply anything other than medical oxygen.
Remember that in continuous flow mode, the Oxygen will be consumed at a much faster rate. Switch to another oxygen
81 2
source before depleting the oxygen cylinder. The continuous flow function on the OM-812CE pneumatic oxygen conserver
6