DRESSTA 515C, Руководство оператора, Страница: 83 / 205

SECTION 4
OPERATING
Page 34
OM515C520C99/1E DRESSTA
4.16. PARKING THE MACHINE
WARNING!: When parking the machine observe the following rules:
a) Park the machine in a non-traffic area. If parking in traffic lanes cannot be
avoided, provide appropriate flags, barriers, flares, and warning signals. Also
provide advance warning signals in the traffic lane for approaching traffic.
b) Always lock the machine, including any anti-vandalism attachments, when
leaving the machine unattended.
C) Avoid parking on a slope, however, if parking on a hillside is necessary, park
at the right angle to the hill and block the tires as shown in Fig. 4.27.
NOTE: Avoid parking the machine in puddles of oil, grease or gasoline because this damages the
tires.
Fig. 4.27. Hillside Parking
NOTE: Park the machine on level ground to obtain accurate coolant, lubricant, hydraulic, fuel level
checks.
4.17. LOADER OPERATIONS
The loader equipment is hydraulically operated. When the bucket circuit is being operated, oil flow
to the boom is cut off.
IMPORTANT: Holding the control lever in any position except B "hold" and D “float" for an
extended period of time after the hydraulic cylinder rod has reached the limit of its travel will
produce excessive heat in the hydraulic system which may affect loader performance.
4.17.1. BOOM CONTROL LEVER POSITIONS (Fig. 4.28.)
Fig. 4.28. Boom Control Lever Positions (Standard Version)
A. Raise B. Hold C. Lower D. Float