DRESSTA 32501, Руководство оператора

Страница: 79 / 177

OPERATING
SECTION 4
Page 33
DRESSTA TD-15H
OPERATING MOUNTED EQUIPMENT
Fig. 4.32. Upper Strut Adjustment of Angle Blade.
1. Eyebolt
2. Strut Body 3. Locking Pin
4. Eyebolt
4.17.8.5. LEVELLING THE BLADE WITH HYDRAULIC TILT
1. Place the lowest corner of the blade on a flat surface.
2. Move the control lever to this side to which the blade is to be lowered until the blade is even
along the flat surface.
4.18. OPERATING TECHNIQUES
WARNING! Before operating a machine, be sure the area of the operator's
compartment, all mounting steps and grab handles are free of oil, grease, loose
objects, ice, snow and mud to lessen the possibility of slipping. Remove or
secure all maintenance and personal items so they will not interfere with the
operator or jam the controls. Failure to follow these instructions may result in
serious injury.
When the blade is held hydraulically it becomes a rigid part of the tractor, except when the valve is
in “FLOAT” position, and will follow all movements of the machine. When rough terrain is
encountered it will be necessary to vary the height of the blade while pitching to obtain a smooth
cut. When possible, start all jobs from relatively level ground. If necessary, level an area large
enough to provide sufficient working space for the machine. This prevents back and forth pitch of
the machine and will result in easier digging.
Avoid track spinning whenever possible; this wastes effort and converts a relatively smooth
working area into ruts and piles that pitch and tilt a tractor. In cold weather this material can freeze
and cause additional difficulty the following day.
Crossing ditches, ridges, rock or logs should be done slowly and, at an angle. This slows the fall,
lessens the danger of upsetting the machine and reduces the fall jolt, which can be harmful to the
operator and machine.
https://www.truck-manuals.net/