Dreamline UNIDOOR B, Руководство по установке

Страница: 14 / 39

“UNIDOOR” Single Shower Door Ver.2 Rev.2 06/2016
13
2. The Door Glass (01) ships with four 5/8” shims
attached to the top (2pcs) and bottom (2pcs).
Determine the swing of your door and only remove the
shims from the top of the door glass, leaving the
bottom shims in place. Set the Door Glass (01) onto
the threshold at the desired location and check for level.
These 5/8” shims will leave the proper spacing at the
bottom of the door glass and will ensure that the door
height finishes at 72”, but always confirm with a
measurement. Carefully butt the door with the hinged
side against the wall, adjust its position and check for
plumb with a level.
ATTENTION:
Check the door glass with a level to verify that it is
plumb before marking the hinge positions.
See Fig. 2 for details.
TIP:
If installing the door along with panel glass, use the
72" Anti-Water strip (Inline) (19) that is packed with
the panel glass as a reference to be sure that the door
height will match the panel glass at 72".
3. Hold the door in place and mark the drill
holes for both Hinges (05) on the wall. Set
the door aside and drill the holes in the wall
using Ø 1/4” drill bit.
IMPORTANT:
The included PVC hinge spacers (31) are
provided to compensate for minor out-
of-plumb wall conditions. Use only as
needed as their use could compromise
the opening size of your shower. Please
see Fig 4 for an installation example.
Place the Door Glass (01) back onto the
threshold with the 5/8” spacers and attach
both hinges to the wall with only two
Countersunk screws ST5×70 (04) on the
hinge from outside of the shower. Then
open the door and install the remaining
screws to the inside of each hinge.
See Fig. 3 and Fig. 4 for details.
2
1
3
Ø 1/4"
outside
outside
ATTENTION:
This door is extremely
heavy and the hinges
on this door must be
attached to the studs
or to preinstalled 2
×
6
wood reinforcement
behind the wall.
Fig. 2
Fig. 3