Rev 1.6
8
9.
Move the finished frame to the designated
position on the shower base, the bathtub or the
threshold (depending on your installation); push it
against the walls. If your top and bottom wall
opening measurements are different or if the
walls are out-of-plumb, make adjustment by
slightly pulling the
Wall profiles (02)
out of the
Glass Profiles (01)
.
Use the level to adjust the frame in the vertical
position
See Fig. 9 for details.
Fig
. 9
10.
Using help to hold this assembly in the right
position, mark the drill holes on the wall through
the holes on the flange of the
Wall Profiles (02)
.
11.
Gently set the assembled unit aside; drill the holes
using
Ø 5/16”
drill bit and insert the
Wall anchors
(1
5
).
Apply silicone caulk along the
W
all profiles
and
around the holes on the wall. Also apply silicone
under the bottom
Guide rail (03)
. Place the whole
shower assembly back into the designated position
and secure it to the walls using the
Round head
screws ST4.2×30 (10)
.
See Fig. 10 for details.
Fig
. 10
Ø5/16”
2
1
3
4
5
6