8
AQUALUX manual Ver 2 Rev 4 02/2016
1
2
Fig 7
Fig 8
5
6
7
1
2
3
Ø 5/16”
4
door
panel
inside
7.
Locate the
Support bar (02)
.
Position the
Support bar (02)
at an angle (ideally
45°) between the glass and the wall. Level it
horizontally. Hold it firmly and outline the bracket’s
position on the wall. Remove the
Support bar (02)
and detach the wall bracket from it. Place the wall
bracket against its outlined position on the wall
and mark the drilling hole.
Drill a hole using a
Ø 5/16”
drill bit, insert the
Wall
anchor (07)
and fasten the wall bracket to the wall
with the
Countersunk Screw ST4.2×40 (13)
.
Attach the
Support bar (02)
to the bracket as
shown in Fig. 7.5 and tighten the set screws and
the glass holding screw to secure the glass. Be sure
to install the gaskets to protect the glass.
See Fig 7 for details
8.
Align the hinges with the edge of the glass and
attach the
Hinges (03)
to the
Stationary glass (01)
with the decorative bolts facing inside the shower.
*
Bring the
Glass door (04)
into the tub area and
align it with the
Stationary glass (01)
.
Fasten the
Hinges (03)
onto the
Glass door (04).
Make sure the top edges of the
Glass door (04)
and
the
Stationary glass (01)
are aligned.
See Fig 8 & 9 for details
*TIP
: Use a 3/4” shim beneath the door glass to assist
with aligning the door glass with the installed hinges
and to maintain the proper spacing beneath the door
glass.
Note:
Use the same combination of hinge gaskets on
both hinges for the inside and outside hinge plates.