© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
Tools Needed
Parts Needed
ALLIANCE PRO/ALLIANCE PRO LT Shower Door Manual Ver 1 2/2021
10
© 2021 DreamLine® All Rights Reserved
04a
x1
03
x6
Apply silicone to the backs of the
Wall Profiles (#01)
, then install the
Wall Profiles
using the
ST4.2 x 35mm
Truss Head Screws (#03)
. The
Bottom Bumper (#04a) (Fig 3.3)
is also installed using the
ST4.2 x 35mm
Truss Head Screws (#03)
while installing the
Wall Profile (#01)
on the shower head side of the shower
.
Install it in the lowest screw hole on the
Wall Profile (#01)
. The remaining
Bumpers (#04)
are installed after
both
Wall Profiles (#01)
are installed. The two upper
Bumpers (#04)
are installed using the
ST4.0 x 14mm
Pan Head Screw (#05). Fig 3
NOTE
04
x2
Right-side shower head installation shown as example
TIP
Note the opposite orientation of the two upper
Bumpers
(#04)
. The bumper slot for the
Inside Door Glass (#09)
faces the inside of the shower on the shower head side.
Fig 3.4
The bumper slot for the
Outside Door Glass
(#10)
faces the outside of the shower on the opposite
wall.
Fig 3.5
Apply dish soap to the
screw threads and use
a Phillips screwdriver to
install screws to avoid
stripping the screws
Reversible Screw
holes for two upper
Bumpers (#04)
Fig 3
TIP
1
4
6
5
2
3
3
05
x2