Distance should be equal
Distance should be equal
5
4.
Partially slide the Bolts with Rubber Pads and Tension Knobs outwards from the Gate Frames /
Extension Frames into Mounting Cups.
5.
Tighten both of the bottom Tension Knobs (5A) by
turning them clockwise at the same time (5A & 5B).
NOTE: Make sure the bottom of the gate frame
remains completely flat on the floor.
Next, tighten both of the Tension Knobs at the top at
the same time by turning them clockwise (5C).
6.
Tighten the Tension Knobs until the two Indicator
Lines, located on the Upper Locking Set and on the
Right Upper Corner, align horizontally (6A).
5A
Indicator
Lines
Keep this gap about
1mm / 0.04in
6A
When correctly tightened, the distances
between Tension Knobs and Rubber Pads
should be equal (6B, 6C).
5C
Note: When first installing, the gate will have
this gap. This is normal and will disappear
when gate is completely installed.
Tighten
inward
Tighten
inward
5B
Tighten
inward
Gate frame
Tension knob
Tighten inward and align the Indicator Lines
6C
6B
