Dreadbox DYSMETRIA, Руководство по монтажу

Страница: 5 / 41

2. Soldering the components
STEP 1 - Resistors (bag 1.3)
Remove all the resistors from Bag 1.3. Before
you start soldering, measure them and note their
value on their tape, as shown on the photos.
Remember that resistors have a 1% to 5%
tolerance, so for example, a 10k resistor might be
measured from about 9.500 ohm to 10.500 ohm.
The maximum temperature for this step on the soldering iron should be 380º C.
We strongly suggest though, to set it at about 310º-320º degrees.