Models:
13616/13618/13619
Models:
13616/13618/13619
Default Settings
The maximum and minimum setpoints are preset in the factory to
65
o
C and 60
o
C respectively.
06490084001 ISS H
06490084001 ISS H
Simple Setting or Operating
To set the required temperature
• The display normally shows the current setpoint.
• To adjust the required temperature, turn the
dial clockwise to increase or anti-clockwise to
decrease, (1 click = 5ºC), the LCD will display
the temperature setpoint as it is being
adjusted and ‘SET’ will be displayed. After a
few seconds the display will return to normal
operation and will display the current setpoint.
DHW Cylinder Thermostat
To assist with commissioning or checking the system operation,
there is a positive OFF setting outside the temperature scale on the
cylinder thermostat. First adjust the minimum temperature setting
to 40
o
C as described in the user guide, then rotate the dial fully
anticlockwise for OFF.
‘Boost 1 Hr’
DC RF
DC RF
DC RF
should now display the ‘E2’ and the RF symbol ‘ ’. If
DC RF
DC RF
DC RF
DC RF
the
DC RF
transmitter unit and sensor can be installed.
When the sensor is wired to the transmitter unit, the display will
change after approx. 30 seconds to show the current setpoint and
‘E2’ will disappear
DC RF
Boost 1 Hr
BOILER
30cm Min
Preferred side of boiler
The range may be affected by
composition/density and number of walls
between the DiCRF and SCR
230V a.c.
230V a.c.
DC RF
Heating
Radio Signal Range:
30m Typically
SCR
Technical Helpline: +44 (0) 845 130 7722
www.draytoncontrols.co.uk
Email: [email protected]
Digistat
+
CRF
Digistat
+
CRF
ON
RECEIVE / ALARM
OVERRIDE
LEARN
MODE
1
2
Wireless System
Digistat
+C SCR
Technical Helpline: +44 (0) 845 130 7722
www.draytoncontrols.co.uk
Email: [email protected]
