Draper 59319, Инструкция по эксплуатации, Страница: 5 / 12

PREPARATION Cont’d.
SETTING THE SECURITY CODE
A programmable 4-position security code switch is built-
in the alarm unit and the remote control to prevent other
transmitters or radio devices from sounding the unit. Each
unit is factory preset.
To change The Factory Preset Code On The Sensor
Alarm Unit:
1. Locate programmable switch inside the battery
compartment.
2. Set the desired switch position.
3. Replace the alarm unit into the back cover.
To Change The Factory Preset Code On The Remote
Unit:
1. Locate programmable switch inside the battery
compartment.
2. Set the desired switch position.
3. Replace battery compartment cover.
Notes:
The remote must be set to the same code settings (same
numbers) as the alarm unit in order for the remote control
to function.
Do not set all the code settings to ‘0’.
Try arming and disarming your sensor alarm to be sure if
it recognizes the remote control (see Alarm Operation -
Arming Alarm and Disarming Alarm on page 6.
- 4-