Dragino LDS03A, Руководство пользователя

Страница: 8 / 33

www.dragino.com
LDS03A Outdoor Open/Close Door Sensor
8 / 33
1.6 Pin Definitions and Switch
LDS03A is based on LSN50v2
1.6.1 Pin Definition
The device is pre-configured to connect to a door sensor. The other pins are not used. If user
wants to know more about other pins, please refer to the user manual of LSN50v2 at:
http://www.dragino.com/downloads/index.php?dir=LSN50-LoRaST/
1.6.2 Jumper JP2(Power ON/OFF)
Power on Device when putting this jumper.
1.6.3 BOOT MODE / SW1
1) ISP: upgrade mode, device won't have any signal in this mode. but ready for upgrade firmware.
LED won't work. Firmware won’t run.
2) Flash: work mode, the device starts to work and send out console output for further debug
1.6.4 Reset Button
Press to reboot the device.
1.6.5 LED
It will flash:
1) Boot the device in flash mode
2) Send an uplink packet