Dräger Multi-PID 2, Руководство пользователя

Страница: 78 / 107

78
Routine Maintenance
Battery Charging
A fully charged battery pack powers the Multi-PID 2 for approximately
5,5 hours. If the instrument is to be used for more than 5,5 hours,
carry a spare battery pack (Part No. 83 23 622 or 83 17 670). When
the first one has been discharged, replace it with the spare.
When the Multi-PID 2 displays the low battery symbol, the battery
pack requires charging. When the low battery symbol is displayed,
you have 30 minutes of operation left. The Multi-PID 2 will turn itself
off before the battery pack becomes critically low.
Upon return from field work, charge the battery packs as outlined in
Battery Charging on page 26. Use only the AC adapter specified for
use with the Multi-PID 2. Optionally you can use the off-line charger to
charge the battery pack independently of the instrument. See Off-
Line Charger on page 50.
If you do not require portable operation, you can use the Multi-PID 2
while it is connected to the AC adapter.
When the Charge LED on the top of the Multi-PID 2 is red, the battery
is charging. When the Charge LED turns green, the battery is fully
charged.
NOTE:
If you do not turn the Multi-PID 2 off before removing the battery
pack, you will reset the instrument and you will lose all logged
data and setup parameters.
WARNING:
Do not remove or recharge the battery pack in a
hazardous location.
NOTE:
You must use the 220 V battery charger (Part No. 83 17 661) in
order to comply with the requirements of the applicable Council
Directives.
WARNING:
The Multi-PID 2 is not intrinsically safe when con-
nected to an AC adapter.