Dräger Infinity Delta, Инструкция по эксплуатации

Страница: 474 / 614

27-6 D
ELTA
/D
ELTA
XL/K
APPA
VF8
27 B
ODY
T
EMPERATURE
Temperature Setup
To access the temperature setup menu
Click on the desired temperature parameter box (if displayed);
or
1. Press the
Menu
fixed key.
2. Click on
Patient Setup
.
3. Click on
Parameters
.
4. Click on
TEMP , TEMP2
or
TEMP3 ,
depending on which temperature signal
you wish to monitor (see page
27-4
).
The TEMP setup menu displays only two items:
TEMP display
– Configures the bottom half of the parameter box to display
either the reading of the second temperature probe (b) or the difference
between the first probe’s reading and the second (
DT,
the delta value).
TEMP alarms
– Accesses temperature alarm settings on the Alarm Limits table
(see page 5-6).
Status Messages
Message Possible Cause Suggested Action
> #
< # The temperature exceeds the
upper or lower alarm limits.
• Check the patient and treat, if
necessary.
• Check equipment and replace if
necessary.
Out of Range (High)
Out of Range (Low) The temperature value is greater
or less than the measuring range.
Can’t Derive
Δ
T(#) The cable is defective or
unplugged.
• Check equipment and replace if
necessary.
• Connect the second temperature
probe.
Unplugged Check the equipment and replace if
necessary.
H/W Failure Temperature circuitry failure. Contact DrägerService.