Dräger Medical Narkomed GS, Руководство по установке и настройке

Страница: 72 / 92

6-20
NMGS PMC PROCEDURE (continued)
6.8.7.5 Disconnect the pressure pilot line from the Bain Circuit and
replace it with a PDM To Monitor Adapter (P/N 4115041).
6.8.7.6 Connect a test gauge to the adapter.
6.8.7.7 Occlude the expiration port on the Bain Circuit.
6.8.7.8 Apply 50cm H
2
O test pressure to the Bain Circuit.
6.8.7.9 Is the pressure indicated on the cm H
2
O gauge within 3 cm
H
2
O of the digital pressure meter reading? ___ (Y)
6.8.7.10 After 30 seconds, is the test pressure 45 to 50 cm H
2
O?
___ (Y)
6.8.7.11 Open the APL valve by turning the knob fully counter-
clockwise.
6.8.7.12 Connect a Fresh Gas Outlet Volume Adapter (P/N S010158)
between the fresh gas outlet and the Expiration port of the
Bain Circuit.
6.8.7.13 Set the O
2
flow to 8 l/min.
6.8.7.14 Is the test pressure within 0 to 3 cm H
2
O? ___ (Y)
6.8.7.15 Remove the test equipment and reconnect the pilot line to
the Bain Circuit.
6.9 OXYGEN ANALYZER
6.9.1 Press the CAL key.
NOTE: Make sure that the sensor has stabilized in ambient air for
several minutes.
6.9.2 After calibration is completed, is the O
2
concentration 21 %? ___(Y)
6.9.3 The warning message INSP O
2
LOW shall appear on the central alarm
display, and a continuous alarm shall sound.
6.9.4 Press the Alarm Silence key and verify the audio alarm is silenced.
6.9.5 Place the Oxygen sensor into the inspiratory valve dome adapter.
6.9.6 Set the AUTO/MAN selector to BAG.
6.9.7 Close the APL valve.
6.9.8 Attach a 22 mm hose (P/N 9995132) to the inspiratory valve.
6.9.9 Attach a Breathing System Leak Test Device (P/N S010159) to the bag
mount.
6.9.10 Press the O
2
Flush.
6.9.11 After 10 seconds, is the O
2
concentration 90 to 100 % O
2
? ___ (Y)
6.9.12 Release the O
2
Flush, does the flow cease immediately? ___ (Y)
6.9.13 Set the Oxygen flow to 10 l/min.
(
9
)
(
9
)
(
9
)
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS