DR ROTO-HOG Premier Power Tiller, Руководство по безопасности и эксплуатации

Страница: 17 / 28

Contact us at www.DRpower.com 17
Do not move or remove the Belt Guide ( Figure 10 ). If you accidentally alter the position of the Belt Guide, return it to the correct
setting of 6-1/2" above the Tine Shield Support Plate ( Figure 10 ).
Transmission Lubrication
Check the Transmission Oil Level after the first 5 hours of operation. Remove the Oil Fill Plug ( Figure 9 on page 16). The Oil level
must be even with the Plug Hole (with the Tiller level). Add Oil if necessary. Use SAE 30 non-detergent motor Oil. Replace Oil Fill
Plug.
NOTE: It is not necessary to change the Oil in the Tiller Transmission. If for any reason it must be changed, Oil capacity is 22 oz.
Removing and Replacing the V-Belt
Replace the Tine Drive V-Belt if damaged from slipping under heavy loads or if it shows cracks or frayed edges.
Tools and Supplies Needed:

Screwdriver

7/16" Socket
1. Remove the Screws from the top and rear of the Belt Guard using a 7/16"
Socket and remove the Belt Guard. (
Figure 11 ).
2. Disengage the Tine Clutch Lever and remove the worn Belt.
3. Reverse this procedure to install a new Belt.
When performing any maintenance, you must first shut off the Engine; wait five (5) minutes to allow parts to cool and disconnect
the Spark Plug Wire, keeping it away from the Spark Plug.
Figure 10
Figure 11