DR PRO MAX-34, Руководство по безопасности и эксплуатации

Страница: 23 / 48

CONTACT US AT
www.DRpower.com
23
4. Roll the Auger Belt off the front of the Engine Drive Pulley to make room for
removal of the Traction Drive Belt (
Figure 57 ).
Note: It may help to put a 13mm Wrench on the Engine Shaft Bolt and turn
clockwise to aid in rolling the Belts off the Pulley.
5. Remove the Traction Drive Spring from the Frame using Pliers (
Figure 58
).
6. Remove the Traction Drive belt from the Engine Pulley and let it rest in front
of the Pulley.
7. Look under the Frame and observe how the end tabs of the Friction Disc
Bracket are located on both sides of the rear Strut (
Figure 59 ). It is very
important that it is installed this way when reassembled for proper
operation.
8. Remove the Bolts, Lock Washers and Flat Washers that secures the front
Strut to the Frame (
Figure 60 ). The Friction Disc Bracket will now move out
of the way enough for Belt removal.
9. Remove the Traction Drive Belt from the Drive Pulley below and pull it up so
it can be removed from the Pulleys on the Engine Shaft.
10. Install the new Traction Drive Belt onto the Drive Pulley and Engine Pulley.
11. Secure the rear Strut to the Frame. Ensure that the Tabs are on both sides
of the Strut.
12. Install the Traction Drive Spring to the Frame.
13. Install the Auger Belt onto the Pulley.
14. Install the Transmission Cover.
15. Install the Belt Guide.
16. Install the Belt Cover.
Replacing the Traction Drive Belt (PRO 28, 30 and 34 Models)
Tools and Supplies needed:

10mm Wrench

13mm Wrench

Pliers

New DR Belt
1. Remove the two Bolts and rectangular Washers from the Belt Cover using a
10mm Wrench and remove the Belt Cover (
Figure 61
).
Belt
Cover
Figure 61
Bolt and
Rectangular
Washer
Traction
Drive
Spring
Figure 58
Traction
Drive
Belt
Auger
Belt
Figure 57
Auger Drive
Pulley
Tabs
Figure 59
Tabs
Rear Strut
Friction
Pulley
Bolts, Lock
Washers and
Flat Washers
Figure 60