DR PRO MAX-34, Руководство по безопасности и эксплуатации

Страница: 15 / 48

CONTACT US AT
www.DRpower.com
15
Starting the PRO-28, PRO-XL 30, and PRO-MAX 34 Engines
(Manual Start)
1. Insert the Key into the Key Slot (
Figure 29
).
2. Make sure the Fuel Shutoff is turned counterclockwise to the open position.
3. PRO-28 - Move the Choke Control Lever to the left “choke” position (leave
in the right “Run” position if the engine is already warm).
4. PRO-XL 30 and PRO-Max 34 - Turn the Choke Control Lever
counterclockwise to the choke position (leave in the clockwise run position
if the engine is already warm).
5. Push and release the Primer Bulb 3 times.
6. Slowly pull the Starter Cord until you feel resistance, then pull quickly
(
Figure 30 ). The Cord will recoil back into position when released.
7. As the engine warms up, slowly adjust the Choke clockwise. Wait until the
engine runs smoothly before each Choke adjustment.
8. When the Engine is warmed up and running smoothly, ensure that the
Choke is fully in the clockwise position and the Throttle Lever is fully to the
right.
Starting the PRO-28, PRO-XL 30, and PRO-MAX 34 Engines
(Electric Start)
1. Insert the Key into the Key Slot ( Figure 29 ).
2. Make sure the Fuel Shutoff is turned counterclockwise to the open position.
3. PRO-28 - Move the Choke Control Lever to the left “choke” position (leave
in the right “Run” position if the engine is already warm).
4. PRO-XL 30 and PRO-Max 34 - Turn the Choke Control Lever
counterclockwise to the choke position (leave in the clockwise run position
if the engine is already warm).
5. Connect the required Heavy-Duty extension cord into the Snow Blower
Control Box (
Figure 31 ) and plug the Extension cord into a 120V outlet.
6. Push the Starter Button on the Snow Thrower Control Box until the engine starts and then release the Button.
NOTICE: Do not push the Starter Button more than 10 times at intervals of 5 seconds on/ 5 seconds off. If the Engine will not start, see
the Troubleshooting section in Chapter 5 of this manual.
7. As the engine warms up, slowly adjust the Choke clockwise. Wait until the engine runs smoothly before each Choke
adjustment.
8. When the Engine is warmed up and running smoothly, ensure that the Choke is fully in the clockwise position and the
Throttle Lever is fully to the right.
Stopping the Engine
1. Pull the Key out of the Key Slot to stop the Engine ( Figure 29 ).
Starter
Control
Box
Figure 31
Starter
Button
Starter
Cord
Figure 30
Key
Figure 29
Fuel
Shutoff
Throttle
Lever
Choke
Primer
Bulb
Read and understand the warnings listed in Chapter 2 “Safety with starting
machines using an Extension Cord” before connecting an Extension Cord.