4
Front Panel Connections
4
Fig. 3.
The NetGuardian E16 DX G2 Front Panel Controls
The craft port, Ack, and LED displays are accessed via the front panel, as seen in Figure 3.
Rear Panel Connections
5
Fig. 4.
NetGuardian E16 DX G2 rear panel connections
Connectors for power feeds, alarm inputs, control outputs, and communication lines are on the back panel of the
NetGuardian E16, as shown in Figure 4.
LAN Connection
6
To connect the unit to LAN, insert a standard RJ45 Ethernet cable into the 10/100BaseT Ethernet port on the back
of the unit. If the LAN connection is OK, the LNK LED will light
SOLID GREEN
. The LAN connection may be used
for upgrading the firmware or testing but is not required for the equipment to function properly.
