16
Bypass Password
9
Hold button while unit is booting up to bypass password in the event of a forgotten password.
Setting the DCP Address
10
To set the DCP address on the NetGuardian E16 DX G2, connect to the TTY interface.
Note: The default DCP address is '1'. Most likely you will not need to change this.
To connect to the TTY interface,
connect a serial port on your PC to the front craft port on the E16 DX G2 using
the included USB cable.
Use terminal software such as Hyperterminal or PuTTY to establish a connection (9600 baud).
Fig. 13 - The procedure for setting the DCP address on the NetGuardian E16 DX G2 via the TTY interface.
